Traffic control signs12/25/2023 ![]() ![]() When two or more traffic control persons are required to work as a team at the worksite, responsibility for the coordination of changes in traffic flow should be assigned to one person. Always check with the other traffic control person to see if it is safe to allow traffic to move. Work as a team with other traffic control persons.Keep visual contact with the other traffic control person if you are not using radios.Do not stand too close to the taper or in the travel lane. In general, this spot is halfway between the beginning of the taper or detour zone, and the traffic control warning sign. This position will vary with the visibility, speed, and volume of traffic. Stand the correct distance from the work area.Stand “alone.” Do not stand in a group of people, near a vehicle, or other distractions.Know where you will move to if a motorist drives too close. Think ahead and plan your escape route.Stand where you can see traffic, and be seen by traffic. When controlling traffic, as a traffic control person you should: What should a traffic control person do when controlling traffic? Back to top That a traffic control person should never leave their position unattended (e.g., know what the arrangements are for meals and breaks).That measures are in place and at appropriate distances to give motorists enough warning to slow down.That the “stop-slow” sign you will use is in good repair (e.g., undamaged, clean).How communication will be handled if there is a need for a third (or more) traffic control person, such as when the work zone is around curves or hills where sight lines to the other end of the work zone are obstructed.Be sure you have adequate eyesight and hearing ability to do this job safely.What to do in an emergency, including your personal escape route in case a vehicle comes too close.What communication methods will be used, including how to use radios, hand signals, etc.The traffic control zone will vary depending on the speed allowed on the roadway, volume of traffic, weather conditions, if there is a curve or hill, etc. Practices and procedures for that job (how to stop and slow traffic), where to stand, etc.What personal protective equipment is required.What equipment is present and how the equipment will be operated (e.g., scrapers, trucks, graders, etc.).What activities will be done on the work or construction site (e.g., paving, grading, etc.).What training is required and verify that you have the right training for this job. ![]() Your duties, role and responsibilities.The overall traffic protection plan and layout of the traffic control zone.What should a traffic control person know before each job? Back to top Always confirm any requirements with your local jurisdiction. This fact sheet does not cover all of the education or training required for a traffic control person. Northwest Territories requires that the employer ensure the designated signaler is trained to carry out their duties to ensure the signaler’s safety and the safety of other workers. For example, Ontario specifies that each traffic control person receives adequate oral and written instruction from the employer in a language the worker understands before performing traffic control duties. The Canadian Federal jurisdiction’s occupational health and safety laws do not directly address training requirements for a traffic control person.Įach jurisdiction has specific requirements. Most Canadian jurisdictions require that a person who is controlling traffic have training, complete a certificate, or be considered competent. Is training required by occupational health and safety laws? Back to top Always use barriers, barricades, lane control devices, traffic signal lights, sign trucks, and other methods as appropriate. Only use traffic control persons when other methods of traffic control are not adequate. Keep the flow of traffic moving with as few delays as possible.Give traffic control directions and signals clearly and precisely so that motorists understand their meaning.Protect workers in the construction zone by regulating traffic flow.Stop, slow, and safely direct traffic through work or construction sites.What is a traffic control person? Back to topĪ traffic control person may also be known as a flag person or signaller. You are here: Road Work - Traffic Control Person ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |